Extended Dragster Pinewood Derby Car Design

MAXIMUM VELOCITY!^®

Extended Dragster
Pinewood Derby Car Design

Get out of the way! THE DRAGSTER doesn't waste any time getting down the track. Note how the rounded edges give this version a sleek appearance.

In addition to the car kit and basic hand tools, you will need the following supplies to build THE DRAGSTER:

1/4" Brad Point or Forstner drill bit (hardware store item)
Coping saw or another type of saw that can cut a curve
Flat and half round file, and a Shoe Rasp
Wood chisels (1/4" and 1/2")
3-1/2 ounces of segmented lead weight with adhesive removed. These plans assume that each segment is 1/4 ounce and measures 1/2" x 1/2" x 1/8".
Drag Racer decal sheet was used to customize the car in the photo
The extended wheel base can be created by either cutting new axle slots with two hacksaw blades, or by drilling axle holes with the Pro-Body Tool. Instructions and templates are provided in the Car Plans 2 booklet.

Customer Submitted Photos of the Dragster

Dan O'Brien-Mazza - 2002 Bart Jimison & Hunter Fitzwater - 2002 J Olesen - 2004

Copyright © 2012 by Maximum Velocity, Inc.
Ž Maximum Velocity! is a registered trademark of Maximum Velocity, Inc.
Awana is a registered trademark of Awana Clubs International
Pinewood Derby is a registered trademark of Boy Scouts of America