Dominator Kit

The Dominator is very low, sleek, fast, and aggressively weighted. With the Tungsten Canopy, the bulk of the weight is focused in one area, minimizing the rotational inertia of the car.

The Dominator Kit includes a pre-cut and drilled pine block, 3.5 ounce tungsten canopy, tungsten trim weight, and instructions. Weight pockets are located under the car for fine tuning. Wheels and axles are not included, so use the wheels and axles supplied by your club or order them separately.

The Dominator is equipped with precision-drilled axle holes located at an extended position. The holes are drilled with a #44 bit (fits BSA axles). One front axle hole is slightly raised so that the car will ride on three wheels (best performance).

The following standard options are available:

1. 9000 - Drilled axle holes, 4 wheels on the ground - add $1.00.
2. 9002 - Drilled axle holes for Awana axles (3/32" bit) - add $1.00.