Accel Fenders

$13.95

Our 3-D printed, plastic fenders are pre-shaped, and lightweight (lighter than balsa fenders), making it easy for you to get more speed and a cool look. Just lightly sand, glue them on with epoxy, and paint (or paint separately for a two-tone look).

Description

Accel  Fenders are 3-D printed, plastic fenders that are pre-shaped, and lightweight (lighter than balsa fenders), making it easy for you to get more speed and a cool look. Just lightly sand, glue them on with epoxy, and paint (or paint separately for a two-tone look).

The Accel Fenders are hollow with an access hole. So if desired, tungsten putty can be placed into the rear fenders to get more weight on a lightweight car.

Fender Weight

Accel Fenders are lighter than pine or balsa fenders:

Accel Fender Pair: Front-1.1g, Rear-1.3g

Pine Fender Pair(1): Front-3.1g, Rear-3.8g

Balsa Fender Pair(1): Front-1.3g, Rear-2.1g

(1)Estimated weight assuming typical shaping.

Fender Dimensions

As measured from the front tip to the center of the wheel arch:

Front:  1-1/8 inch

Rear:  1-3/8 inch

Aero Fender Instructions

To use the Accel Fenders:

  • Lightly sand the fenders.
  • If a two tone look is desired, paint the fenders separately from the car.
  • Temporarily install a wheel/axle, position a fender to allow clearance for the wheel, then attach the fender with epoxy. Allow the epoxy to cure, then repeat for the other three fenders.
  • If the fenders are not pre-painted, paint the car.

Additional information

Weight 1 oz