MAXIMUM VELOCITY! ^®

Speeder Kit




Standard Wheelbase


Extended Wheelbase



Unlike Luke Skywalker's speeder, THE SPEEDER is real and you can watch it blast down the track. At just 3/8 inch thick, THE SPEEDER easily slips down the track, producing top results.

The Speeder Kit includes a pre-cut and drilled pine block, lead weight, all of the parts to build the 'engines', and instructions. Wheels and axles are not included, so use the wheels and axles supplied by your club or order them separately.

You will need the following to complete the car:

• Hand drill


• 3/32" drill bit


• Epoxy

Two types of standard wheel base versions, and an extended wheel base version are available:

• Standard Wheel Base - Axle Slots: Precision-cut axle slots that match BSA specifications in placement, depth, and width.



• Standard Wheel Base - Axle Holes: Precision-drilled axle holes that match BSA specifications for placement. The holes are drilled with a #44 bit (fits BSA axles). One front axle hole is slightly raised so that the car will ride on three wheels (best performance).



• Extended Wheel Base: Precision-drilled axle holes located at an extended position. The holes are drilled with a #44 bit (fits BSA axles). One front axle hole is slightly raised so that the car will ride on three wheels (best performance).

The following standard options are available:

1. Drilled axle holes, 4 wheels on the ground - add $1.00


2. Drilled axle holes for Awana axles (3/32" bit) - add $1.00


3. Extended wheel base block with standard slots - add $1.00

Stripes & Flames and Custom Designs decal sheets were used to customize the cars in the photos.


Copyright © 2009 by Maximum Velocity, Inc.