Raptor Pinewood Derby Car Kit

MAXIMUM VELOCITY!^®

Raptor
Pinewood Derby Car Kit

The Raptor is a CNC¹ shaped pinewood derby car that is extremely sleek and accurate. It is aggressively weighted with tungsten to give you a very competitive car for races allowing an extended wheelbase.

The car chassis is based on an official BSA block, and the car meets BSA specifications for height, width, length, and underbody clearance. The front left axle hole is drilled slightly higher such that the car will run on 3 wheels. An underbody weight pocket exists to hold the tungsten weight needed to bring the car to 5 ounces.

The kit includes a pre-assembled car body, tungsten weight, and instructions. Wheels and axles are not included, so use the wheels and axles supplied by your club or order them separately.

The paint job shown in this photo was done by Kevin Baugher of Liquid Illusions.

¹CNC stands for Computer Numeric Control. A CNC machine uses a computer to drive the motion and placement of the cutting tools.