MAXIMUM VELOCITY!  ®

Pro-Outer Hub Shaver




Wheel Accuracy = Greater Speed!

The Pro-Outer Hub Shaver1 is a precision machined instrument that will improve the speed of your pine derby car by:

  1. Hub Squaring - The Pro-Outer Hub Shaver ensures accurate rotation by squaring the outer wheel hub to the wheel bore for proper mounting on the Pro-Wheel Mandrel.


  2. Hub Preparation - The Pro-Outer Hub Shaver improves wheel hub to axle head contact by eliminating flaws on the outer wheel hub.
Notes:

  1. The Pro-Outer Hub Shaver is intended for use on wheels from BSA kits. It is not intended for use on wheels from other manufacturers.


  2. A Pro-Hub Tool is required to use the Pro-Outer Hub Shaver.
 To use the Pro-Outer Hub Shaver, follow the instructions below. Click on any of the small pictures to view a larger picture.

1Patent Pending

Pro-Outer Hub Shaver Usage Instructions

Click Here to View the Manufacturer's Video


Square End 		Test Wheels
  1. Remove the protective cap from the square end of the Pro-Hub Tool, and then test fit each wheel by sliding it onto the pin. If the wheel bore is too small for the tool, use steady hand pressure and a twisting motion to work the wheel onto the tool. Remove the wheel and repeat 3 times.

Mount Tool 		Mount Pro-Outer Hub Shaver
  1. Slide the Pro-Outer Hub Shaver onto the pin of the Pro-Hub Tool with the cutting edge outwards. To minimize the risk of a hand injury, leave the protective cap on the coned end of the Pro-Hub Tool.

Square Hub 		Square the Hubs
  1. Place a wheel onto the pin of the tool, spoke-side first.


  2. With one hand hold the Pro-Hub Tool and the Pro-Outer Hub Shaver, and with the other hand press the wheel against the tool. Rotate the wheel three complete revolutions.


  3. Check the outer hub and repeat if needed. But avoid cutting too deep into the wheel.


  4. Repeat steps 3 to 5 for the other wheels.




Copyright © 2009 by Maximum Velocity