Titan - Titanium Grooved Axles
for Pinewood Derby Cars
by DerbyWorx

Titan - Titanium Grooved Axless

The ultimate in axle technology. These titanium axles are precision, CNC-machined for top performance. They are equipped with a two-step, straight, round, and smooth shaft, and a slightly tapered head to reduce wheel-to-axle contact.

The two step shaft provides a good fit with BSA, PineCar, Awana, and MV wheels, while simplifying installation into the block. In addition no preparation is required1 as there are NO BURRS OR CRIMP MARKS, and the axles have a smooth hard finish.



Titanium Grooved Axles substitute for official BSA, PineCar, and other nail type axles.2 However, while these axles closely resemble BSA axles, they are not the official nail, and are not exact replicas.

Technical Information
Shaft Diameter:   .088 inch ± 0.0005 and .093 inch ± 0.0005 (BSA: 0.088 ± 0.002)

Head Diameter:   .208 inch ± 0.0005 (BSA: 0.208 ± 0.004)

Shaft Length:   1 inch   (BSA: Same)

Weight:   0.5g per axle    (BSA: 0.83g)

Material:   Titanium   (BSA: Zinc-coated steel)

1These axles will perform well with no preparation. However, polishing will improve performance. We recommend using the two finest papers in our axle polishing kit or our Axle Polish.

2The Titanium Grooved Axles are not intended for use with our Outlaw Wheels.

Copyright © 2016 by Maximum Velocity, Inc.
Maximum Velocity! is a registered trademark of Maximum Velocity, Inc.
Awana is a registered trademark of Awana Clubs International
Pinewood Derby is a registered trademark of Boy Scouts of America
PineCar is a registered trademark of PineCar